Manual

Care and Cleaning
Bcverag'e (enter
Unplug the beverage center before cleaning. If the unit is in a built-in location,
remove power at the circuit breaker.
Cleaning
the outside
Tile exterior surfaces can be washed with
mild soap arrd water. Rinse thoroughly
with cleat water. Never use abrasive
scouring powders.
Do not use scouring pads, powdered
cleaners, bleach or cleaners containing
bleach because these products can scratch
and damage the finish.
Warranty does not cover damage due to
improper cleaning methods.
Glass door
Use a glass cleaner or mild soap and water
and a soft cloth to clean the glass door
Do not use any abrasive powders.
Avoid cleaning cold glass with hot water
because the extreme temperature
difference may cause it to break. Rough
handling of tempered glass can cause it
to shatter.
Do not place magnets on or near the
glass door. Magnets may cause permanent
damage to the door.
Door gasket Tile vinyl gasket may be cleaned with mild
soap and water, a baking soda solution or
a mild scouring powden Rinse well.
Alter cleaning tire door gasket, apply a
thin layer of paraffin wax or petroleum
jelly' to the door gasket at the hinge side.
This helps kee I) the gasket fiom sticking
arrd bending out of sit ape.
Light bulb
replacement
Unplug the beverage center before
replacing the light bulb. If the unit is
in a built-in location, remove power
at the circuit breaker.
To remove tire light shield, push in the tab
on the left side of the shield and lower it.
Replace with a 15 watt appliance bull).
In the event
4 apowo
failure
If tire power fails, open the door as
irffrequently as possil)le to maintain
the temperature.
Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
Preparing
to 17_love
Secure all loose items such as shelves arrd Be sure the beverage center stays in an
drawers by taping them securely ira place upright position during moving.
to prevent damage.
11