Installation guide

Installation Instructions for ZIP75WW, ZIP75BB Kit
BEFORE YOU BEGIN
Read these instructions completely and
carefully.
• IMPORTANT- Save these instructions for
local inspector's use.
• IMPORTANT- Observe all governing codes
and ordinances.
• Note to Installer- Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these instructions with
your Owner's Manual for future reference.
WARNING:
To prevent electric shock, disconnect
electrical power supply to ice machine
before installing front panel. Do not operate
ice machine while installing panel.
AVERTISSEMENT :
Pour _viter les chocs _lectriques, il faut
debrancher I'alimentation du distibuteur
de glace avant d'installer le panneau avant.
Le distributeur de glace ne dolt pas _tre
en marche pendant I'installation du
panneau avant.
Kit Contents:
• 2 side trim pieces
• 8 side trim screws
• Door handle
Tools and Materials Required:
• 8 flat head wood screws, 1/2" long
• Drill and 1/8" bit
• Safety glasses
• Tape
• Custom panel
NOTE: If installing a 3/4" trimless custom panel, a
3/4"wide filler strip or side panel may be required.
The filler strip will act as a spacer between the
icemaker case and the adjacent cabinet, and will
prevent interference with the icemaker door swing.
The width of the cutout opening must include the
additional width of the filler panels.
This kit contains a new handle and 2 side mounting
brackets to support a trimless custom door panel
up to 3/4"thick. A custom handle may replace the
supplied handle.
IMPORTANT:
• Cut edges of the custom door panel will be seen and
must be finished for best appearance. The back side
of the panel should be finished a minimum of 1/2"
on all sides.
• The custom panel, both raised and flat design,
should be constructed in the same manner as typical
cabinet doors.
• Order the custom panel from the cabinet manufacturer.
Be sure to provide the exact dimensions so that the
panel is constructed accurately.
29-1/2" I
Left Trim
Custom
Panel
14_23/32"
Right Trim