Installation guide

Installation Instructions for ZIP75WW, ZIP75BB Kit
I STEP1 DISCONNECT POWER
TO THE ICE MACHINE
STEP 2 REMOVE HANDLE
AND NAMEPLATE
• Remove the door handle bg removing the two top
mounting screws. Set screws aside. Discard handle.
• The Monogram nameplate is held in place with
adhesive. Remove the nameplate.
STEP 3 MARK MOUNTING
SCREW LOCATIONS
• Align and hold the side trim pieces against the
icemaker door and mark screw locations on the sides.
• Drill 1/8" pilot holes into the door sides of the
icemaken
STEP4 SECURE CUSTOM HANDLE
TO CUSTOM PANEL.
(SKIP THIS STEP IF
YOU ARE USING THE
SUPPLIED HANDLE)
A custom handle can be installed onto the 3//4"
thick panel, replacing the supplied handle.
• The custom handle can be installed at the top
or side of the panel.
• Drill pilot holes through the front of the custom
panel to match the chosen handle.
• Secure the handle to the panel with flat head
wood screws.
• Replace original handle screws in the top of
the door frame.
STEP 5 SECURE SIDE TRIM PIECES
TO CUSTOM PANEL
• Lag the custom panel appearance-side-down
on a clean surface.
• Align top and bottom side trim to the custom
panel sides,
• Tope the side trim pieces to the back of the
custom panel.
• Place the panel with trim against the door to be
sure that trim and panel fits the door side to side
and top to bottom, Adjust as needed.
• Mark screw locations and remove trim.
Drill pilot holes.
• Install side trim to the back side of the custom
panel with screws (not supplied). Use flat head
wood screws approximatelg 1/2" long.
STEP 6 INSTALL ASSEMBLED PANEL
ONTO THE ICE MACHINE
• Install panel to icemaker with supplied screws,
four on each side.
STEP 7 INSTALL SUPPLIED DOOR
HANDLE (IF USED)
• Install the new supplied handle with original screws.
10