Installation guide

Installation Instructions
ADVANCE PLANNING
CAUTION: Duetoexcessive
weight, TWO PEOPLEARE REQUIRED
TO MOVE AND INSTALL THIS ICEMAKER.
Failure to do so can result in back or
other injurg.
MISE EN GARDE :
A cause de son poids _lev_; IL FAUT
DEU× PERSONNES POUR DEPLACER
ET INSTALLER CETTE MACHINE
GLA_ONS. Le non-respect de ces
instructions peut causer des blessures
au dos ou d'autre nature.
WATER SUPPLY
A cold water supplg with water pressure of between
30 and 120 psi is required to operate the icemaker,
If gou have questions about gour water pressure,
call a licensed, qualified plumber.
REVERSEOSMOSIS WATER SUPPLY
IMPORTANT; The performance of the icemaker
mag be affected when it is connected to a reverse
osmosis sgstem,
• The pressure of the water supplg coming out of a
reverse osmosis sgstem going to the water inlet
valve of the icemaker needs to be between 30 and
!20 psk
• If a reverse osmosis water filtration sgstem is
connected to gour cold water supplg, the water
pressure to the reverse osmosis sgstem needs to
be a minimum of/40 to 60 psi. The reverse osmosis
sgstem must provide ! gak of water per hour to
the icemaker for proper icemaker operation.
• Do not use copper tubing when the icemaker is
connected to a reverse osmosis water sgstem.
Choose the location:
Not designed for outdoor installation.
The icemaker must be installed in an area
protected from elements such as wind, rain, water
sprag or drip. The area should be ventilated with
temperatures above 55°F (!3°C) and below !!0°F
(/43°C).Best results are obtained between 70°F
(21°C) and 90°F (32°C).
• The icemaker mag be closed in on the top and
three sides as long as the front is unobstructed
for air circulation and proper operation,
-Installation should be such that the icemaker
can be moved forward for servicing, if necessarg,
-The bottom grille on the front must be
unobstructed to provide proper air flow.
ADVANCE PLANNING (cont.)
Before gou begin:
1. If a custom panel is to be installed, follow the
instructions shown on pages 9 and 10.
-Order ZIP7S (black or white) panel kit.
-Order the custom panel from the cabinet
manufacturer.
-Secure the custom panel onto the icemaker.
2. Determine a method of drainage. If a floor drain
is to be installed, the drain must be accuratelg
located. The installation of a custom door panel
will affect the drain location. See page 6 to
determine the exact location of the floor drain,
front to back, with or without a custom door
panel.
-A drain pump kit, ZPK1, is available and will not
interfere with placement of the icemaker.
3. The door swing is reversible. If desired, change
the door swing before installation.
4. Slide the icemaker into the installation location,
-Open and close the door to be sure there is no
interference.
-Check to be sure the icemaker can be moved
back into the opening, flush with adjacent
cabinetrg. There should be no interference
with the floor drain.
-Check to be sure the icemaker is level. The
icemaker will not operate properlg if it is not
level. See page 5.