Installation guide

Installation Instructions
POWER SUPPLY
WARNING: (Pleasereadcarefully).FOR PERSONAL SAFETY,THIS APPLIANCE
MUST BEPROPERLY GROUNDED. Failure
to follow these instructions can result
in death, fire or electrical shock.
AVERTISSEMENT:
(S'ilvous lisezavec soin). POURVOTRE
SI_CURITI_,CETAPPAREILDOlT/:TRE
CORRECTEMENTMIS/_ LA TERRE.Le
non-respect de ces instructions peut causer
la mort, un incendie OUun choc _lectrique.
Do not use an extension cord or adapter plug with
this appliance. Follow National Electrical Code or
prevailing local codes and ordinances.
This icemaker must be supplied with l15V, 60Hz,
and connected to an individual, properlg grounded
branch circuit, and protected bg a 15 or 20 amp
circuit breaker or time delag fuse.
Electrical Supply Should
Enter From Back Wall
In Shaded Area.
• A properlg grounded three-prong receptacle should
be located within reach of the icemaker's 66" long
power cord. For a built-in installation, locate the
receptacle in the shaded area shown.
IM PORTANT: (Please read carefully).
The power cord of this appliance is
equipped with a three-prong _-__l_i]
(grounding) plug that mates with a
standard three-prong grounding wall
receptacle to minimize the possibilitg
of electric shock. The customer
should have the wall receptacle and circuit checked
bg a qualified electrician to make sure the receptacle
is properlg grounded and has the correct polaritg.
• Where a standard two-prong wall receptacle is
encountered, it is the personal responsibilitg and
obligation of the customer to have it replaced with
a properlg grounded three-prong wall receptacle.
Do not, under ang circumstances, cut or remove
the third (ground) prong from the power cord.
DO NOT USE AN EXTENSION CORD.
REMOVE PACKAGING AND PARTS
• Lag the cartonon rearface
and breakopen the bottom
flap.
• Set the carton upright
with all four bottom flaps
outward.
• Lift carton up and off
icemaker. Open Bottom Flaps
• Remove all tape and
packaging material from the outside and inside
of the cabinet.
ADJUST HEIGHT AND
LEVEL THE ICEHAKER
Height adjustments mag be necessarg to install
the icemaker below a countertop, and mag be
accomplished bg adjusting both the front and rear
leveling legs. The icemaker must be level to operate
properlg.
Raise Lower
To level and adjust the height:
• With one person holding the icemaker, carefullg
tilt the machine to access the leveling legs.
• Use an adjustable wrench to turn the legs.
-Turn legs right to lower, turn left to raise the
icemaker.
• Check top and side with a level. Continue
adjusting legs until the icemaker is level and
stable.