Installation guide

Installation Instructions for ZIP75WW, ZIP75BB Kit
• BEFORE YOU BEGIN:
Read these instructions completely and carefully.
• IMPORTANT:
Save these instructions for local inspector's use.
• IMPORTANT:
Observe all governing codes and ordinances.
• Note to Installer - Be sure to leave these
instructions with the Consumer.
• Note to Consumer - Keep these instructions
with gour Owner's Manual for future reference.
WARNING:
Disconnect electrical power supplg to
icemaker before installing front panel.
Do not operate icemaker while installing
panel. Failure to do so can result in death,
fire, or electrical shock.
AVERTISSEHENT :
IIfaut debrancher I'alimentation de la
machine 5 glaqons avant d'installer le
panneau avant. La machine (_glaqons
ne doit pas _tre en marche pendant
I'installation du panneau avant. Le non-
respect de ces instructions peut causer la
mort, un incendie ou un choc 61ectrique.
Kit Contents:
• 2 side trim pieces
• 8 side trim screws
• Door handle
Tools and Materials Required:
• 8 flat head wood screws, 1/2" long
• Drill and 1/8" bit
• Safetg glasses
• Tape
• Custom panel
NOTE: If installing a 3/4" trimless custom panel,
a 1-1/2" wide filler strip mag be required. The filler
strip will act as a spacer between the icemaker
case and the adjacent cabinet, and will prevent
interference with the icemaker door swing when
it is installed between frameless or framed
cabinetrg. The width of the cutout opening must
include the width of the filler strip. The product
cannot be installed flush to adjacent 24" deep
cabinets with a 3/4" thick custom panel.
This kit contains a new handle and two side
mounting brackets to support a trimless custom
door panel up to 3/4" thick. A custom handle
mag replace the supplied handle.
IMPORTANT:
• Cut edges of the custom door panel will be seen
and must be finished for best appearance. The
back side of the panel should be finished a
minimum of 1/2" on all sides.
• The custom panel, both raised and flat design,
should be constructed in the same manner
as tgpical cabinet doors.
• Order the custom panel from the cabinet manufacturer.
Be sureto provide the exact dimensions so that the
panel is constructed accuratelg.
Custom
Panel
14_23/32"
l Handle