Design Guide with Installation Instructions Outdoor/Indoor ZDOD240 monogram.
Safetg Information BEFORE YOU BEGIN: WARNINGS: Read these instructions completely and carefully. • Use this appliance only for its intended purpose. • Immediately repair or replace electrical service cords that become frayed or damaged. • Unplug the unit before cleaning or making repairs. • Repairs should be mode by o qualified service technician. IM PORTANT - Sove these instructions for local inspector's use. IM PORTANT - Observeallgoverning codes and ordinances.
Important Information CONTENTS Design Guide The Installation Space ..................................... 4 Product Clearances and Location Tools,Hardware................................................... 3 Important Information Caring for Your Stainless Steel .....................3 • Before instollotion or first use, we stronglg odvise gou polish the stoinless steel exterior ond hondle with o commerciollg ovoiloble stoinless steel cleoner such os Stoinless Steel Hogic TM.
Design Guide THE INSTALLATION SPACE PRODUCT CLEARANCES AND 23-3/4" /4" Free-Standing NOTE: Handle and handle standoff depth is 2-3/4" - Use canopy top Built-In LOCATION REQUIREMENTS The Outdoor/Indoor Refrigerator is factory set for a 110 ° door swing. When instulled in u corner: • Allow 5-1/4" min. clearance on the hinge side for the 90 ° door swing and to allow racks to slide out. • Allow iS" minimum clearance on the hinge side for a full 110° door swing. • Testthe door swing.
Installation Instructions GROUNDING THE OUTDOOR/ INDOOR REFRIGERATOR GROUNDING WARNING - IMPORTANT: PLEASE READ CAREFULLY. THIS PRODUCT MUST BE CONNECTED TO A POWER SOURCE WITH GROUND FAULT CIRCUIT INTERRUPT (GFCI} PROTECTION WHEN INSTALLED IN AN OUTDOOR LOCATION. LOCAL CODES MAY REQUIRE A SEPARATE CIRCUIT. AVERTISSEMENT CE PRODUIT DOIT i:TRE CONNECTI_ A UNE SOURCE D'ALIMENTATION A DISJONCTEUR DE FUITE A LA TERRE, EN CAS D'INSTALLATION EN PLEIN-AIR.
Installation ISTEP11REMOVE ISTEP31CONNECT PACKAGING • Remove corner blocks and foam drawer stops. • Remove all packing material, tape and protective plastic coverings. CAUTION: Small objects area choke hazard for children. Remove and discard any parts not used. ATTENTION : Les petits objets Instructions peuvent POWER • If the refrigerator is used outdoors, plug the power cord into a GFCIreceptacle. • Check to make sure power is on bg opening the door to see if interior light turns on.
Installation Instructions STAINING WOOD DRAWER FRONTS The drawer fronts are unfinished cherry wood. During use, oil from hands may accumulate and stain the wood. • The drawerfrontsmay be stained and sealedto match adjacent cabinetry. • Apply the stain and sealer according to the manufacturer's instructions. To avoid unpleasant odor, keep the door open to ventilate and allow the stain/sealer to dry completely before using the product.
NOTE: While performing book, safetg glasses installations or goggles should described in this be worn, For Monogram ®local service in gour area, call 1.800.444.1845. NOTE: Product improvement is a continuing endeavor at General ElectrJc. Therefore, materials, appearance and specifications are subject to change without notice. Pub. No. 31-515/42-2 Part No. 197D5893P001 08-07 JR Printed in 81ovenia GE Consumer & Industrial Appliances General Electric Compang Louisville, KY/40225 ge.
