Installation guide

JIlnstallat.ionnstructlons I
Convert Natural Gas to LP Gas Operation
Convert LP Gas to Natural Gas Operation
-AWARNING:Thisconversionmust
be performed by a qualified installer or gas supplier
in accordancewith the manufacturer's instructions
and all codes and requirements of the authority having
jurisdiction. Failure to follow instructions could result
in serious injury or property damage. The qualified
agency performing this work assumes responsibility
for the conversion.
-AWARNING:The rangetop, as shipped from
the factorg, is set for use with its intended gas. If gou
wish to use gour rangetop with the alternate gas, gou
must first replace the orifices and convert the pressure
regulator.
-AWARNING:Thefollowing adjustments
must be made before turning on the burner. Failure to
do so could result in serious injurg. Be sure pressure
regulator has been converted as described in Step 2.
TOOLS YOU NEEDED FOR CONVERSION
CrescentWrench
SafetyGlasses
1/2" Deepwell
SocketWrench
1/4"and7mmNutdrivers
r_
SmallFlat-HeadScrewdriver
(2to 2.4mmor 3/32"tip size,
60mmlong)
Philips
Small Pliers Screwdriver
ORIFICE HOLDER
The range orifice holder
is located behindthe front
access panel at the bottom
of the range.
The rangetop orifice holder BurnerOrifices
is located insidethe range insulation cover.
Additional orifices may be present. Useonlg the orifices
specified in the instructions for gour range or rangetop.
Griddle Grill
Orifice Orifice
CONVERT THE REGULATOR
Disconnect all electrical power at the main circuit
breaker or fuse box.
A. Removethe rearvent RangeRegulator
trim (on ranges onlg)
to accessthe
regulator.The .
Rangetop.regulator is
on the left bottom
corner.
B. Shut offl_hegas supplLIbg closingthe manual shut-off
va ve inthe unit or at the wall.
C. Convertthe pressureregulator:
• Unscrewthe cap with plunger.
• Placeyour thumb against flat side of the plunger and
pressdown to snap the plunger out at the cap.
• Carefullglook at the plunger to locate the NAT
or LPposition.
• Turn the
plunger
over so
that the
desiredgas
is showing
nearthe
bottom.
Cap G,asket
@=/@
_ _--IPlunger
.....
Position_ LPPosition
PressureRegulator
• Snapthe plunger back into the cap.
• Screwthe cap back onto the regulator.
_-I CHANGE BURNER ORIFICES
INSTALLATIONTIP:First removeall
orifices and then start replacing them.
Thiswill helpto prevent the possibilitg
that some mag not be replaced.
A.
B.
BurnerCap
Burner
Removethe burner grates, Head
burner caps and burner heads.
Loosenthe top burner Spark __
orifices using a 7 mm Igniter
nut driver.Usesmall
pliers to carefullg lift out the orifices. BurnerBase
The main orifice is located
low in the center of the
burner,while the simmer
orifice is located higher
beside the center
of the burner. Main
Orifice
Orifice
21