Installation guide
Installation
Instructions
27" Built-In Wall Oven
JKP20, JKP28, JKP48, JK915, JK955, JKS06,
ZEK938, ZEK958
If you have questions, call 1.800.GE.CARES or visit our website at:
www.GEAppliances.com
Before You Begin
Read these instructions carefully and completely.
• IMPORTANT-save these
instructions for local inspector's use.
• IMPORTANT-observe all
governing codes and ordinances.
• Note to InstallermBe sure to leave these
instructions with the consumer.
• Note to ConsumermKeep these
instructions for future reference.
• Proper installation is the responsibility
of the installer and product failure due
to improper installation is NOT covered
under warranty.
• NOTE_This appliance must be properly
grounded.
• ATTENTION INSTALLER
All electric wall ovens must be hard wired
(direct wired) into an approved junction
box. A plug and receptacle is NOT permitted
on these products.
Parts Included
Single Ovens
8 Screws
Double Ovens
12 Screws
Metal
Bottom Trim
Plastic
Bottom Trim
Metal Bottom Trim
Optional
Metal Bottom Trim
Assembly
Materials Needed
Strain Relief Clamp
for 1/2" conduit
_ WireNu_s
Junction
Box ,_
36" of String
Tools You Will Need
1/8" Drill Bit and
Electric or Hand Drill
Phillips
Screwdriver
229c4053P504
31-10523 (06-02 JR)