Use & care guide

12
Under-cabinet
mounting
Tools and materials
required:
•Flat-blade screwdriver
•Phillips screwdriver
•Drill and 1/4" bit
•Nail or center punch
•Pencil and ruler
•Scissors
•Hammer
•Tape
•Safety glasses
•Two brackets (supplied)
To drill
from inside
Template 1
Template 2
•Carefully remove the four plastic plug buttons
from oven top and the two screws at top rear
flange of case.
•Remove the two top case screws on the back
of oven. Retain screws.
•Select correct template and rear brackets for
this model. (See Template/Rear Bracket
Reference Sheet.)
•Secure the two rear brackets to back of the
oven, left and right, using screws removed
earlier.
–Make sure brackets are level and flush with
top surface of case.
•Cut Template 1 along dotted lines.
•Place template 2 inside the cabinet:
–If cabinet is less than 12" deep, cut off front
edge of template to fit, using template cut
lines as a guide.
–If cabinet has a recessed shelf, measure the
thickness of the front rail and cut that
amount off the front edge of template.
This will allow template 2 to lie flat.
•If you have a partition, you must:
–Cut Template 2 into 2 pieces to fit each
side of the partition.
–Position one piece of Template 2 inside the
cabinet with front edge even to cabinet
front edge.
–Position template 1 on front of the cabinet
so that the arrow is aligned with the hole
center line on template 2.
Installation
Microwave Oven
Case
Emboss
Right Side
Left Side
15 13/32"
Mounting holes for the oven should be drilled
from the inside, if cabinet shelves are remov-
able to allow enough space. Holes may be
drilled from bottom, if necessary.
Buttons