Use & care guide

JX827
installation
Installation
Microwave Oven
Tools and materials
required:
•Accessory kit JX827 for
in-wall installation
•2 Phillips head screwdrivers
(#1 & #2)
•Drill and 3/32" drill bit
•Centerpunch or nail
•Pencil and ruler
JX827 Parts List
1. Base Pan
2. Rear Duct
3. Side Covers (2)
4. Top Trim
5. Bottom Trim
6. Side Trims
7. Rear Holddown Brackets
Screws A (9 required 1 extra)
B (4 required 1 extra)
C (10 required 2 extra)
D (4 required 1 extra)
E (4 required 1 extra)
•Drive two screws into the base pan front
flange to temporarily hold in place.
•Slide two rear holddown brackets into slots
in the rear of base pan. Tongues should be
sticking into the base pan and centered in
the slot.
•Mark and drill four 3/32" holes.
•Install both brackets with 2 screws B.
•Remove two screws in the base pan front
flange and slide the base pan straight out.
•Set the base pan into cabinet cutout and
center left and right. Front flange should be
pushed back against front wall, flush with
opening.
•Use the V-notch in the base pan front flange
to center.
•Drill two 3/32" diameter holes into the base
supporting structure, using the two holes in
the base pan front flange as a guide.
8
Screw A Screw B
Screw EScrew DScrew C
Screw B
Screw C
Step 1
Install rear
holddown
brackets
1
B
2
4
5
6
C
A
E
D
7
3
3
Parts Inventory
V Notch
120V/60 Hz
Grounded
Power
Outlet