Manual

Ca -e and Cleaning
Stai_le,_,_ Steel Outdoor Cool;i_g Ce_ter
BIATTIeF
FeD_1073(_[
(o**some model,_)
Ensure the gas supply is off, the knr)bs are in the
OFF position and all smth_ es are _r)ol before
removing a burner.
The grill and range-top burners are cast iron
coated with porcelain enamel. Occasionally
it will be necessaiy to remove surface rust to
ensure proper performance. Frequency r)f
cleaning will depend oil the climate and
location and how often you use the cooking
center. The walls of the burners are thick so
they can withstand many years of use.
To remove the grill burner(s), remove tile grill
rack(s), then lift out the stainless steel radiant
tray(s) with the lava rocks or ceramic briquettes
still oil it. Remove wire shipping ties if present.
Grasp the burner, pull it up and slightly to the
rear of the unit so the bmner head comes off
the brass orifice at the fiont. Angle the burner
sideways and remove. (24" models have two
grill burners.)
To remove the range-top burners (on some
models), remove the top grates. Lift out
aeration pail fiom around the burners. Lift and
remove the flont and rear range-top burners.
The smoker burner (on soule mr)dels) _an be
removed and cleaned by unplugging tile igniter
_dre and lifting out the burner.
To reassemble the burners, replace the burner
by sliding the air shutters over the brass orifice,
centering it in the hole. It is extremely important
to center the burner on the orifice properly.
Be careflfl not to upset the air shutters' original
position (unless readjusting). Lower tile rear
of the burner into the cutouts oil the support
channel and make sure the locating hole in the
burner end is seated over the pin in tile burner
box. Make sure all burners are level and do
not rock.
Oil 24" models, tr) doul)le check if tile two
burners are prr)perly seated r)ver tile brass
r)rifi_ es, yrm _an visually inspect them.
1. Relnove tile two r)uter (r)ntrr)l knobs.
2. Remove tile two screws underneath the
control knobs and the two screws underneath
the control panel.
3. Rotate the control panel finward. (Do not
remove it.)
4. Shine a flashlight in tile gap to make sure tile
burners are over the brass r)rifi_ es. Repla_ e
screws and knobs.
_,_s htubes
_ Venturi tube
Lighter k k,,_ _'__ /
Burner hanger
Air shutters
Range-top burner
Grill burner for 27/36" and 48" models
Grill burners for 24" model
Replace the stainless steel radiant tray so that
the slots in the corners of the tray align with
the projections oil the top of the burner. (On
24" models the stainless steel radiant trays sit
level oil the side supports.) Make sure that it
sits level and does not rock.
I,ight all of the burners and check for proper
flame characteristics. (Do not attempt to light
the burners prior to replacing radiant trays,
grills and aeration pails.) If adjustments are
necessai y refer to the Installation Instructions.
22