Installation guide

Installation Instructions
[STEP 7 ADJUST DOOR SWING
NOTE:This refrigerotor hos o 2-position door stop.
When spoce does not ollow the door to swing open
fullg to 130°, gou mog chonge the door swing to o 90°
opening. Skip this step if door opening is satisfactory
for your installation situation.
PinLocation
For90°
DoorSwing
PinLocation
asShipped
For130°
DoorSwing
Open the door to view the bottom hinge. Note
the door stop pin Iocotions. The pin is foctorg-instolled
in the 130° position.
Close the door. From below, use pliers to unscrew
the door stop ond reinstoll into the 90° position.
STEP 8 INSTALL GRILLE PANEL
(TRIMMED MODELS ONLY)
Roisethe occess ponel to the stop position.
Loosen the screws on the side trim behind the frome.
Remove the bottom trim.
Slide the ponel over the metol boker ponel
ond into the trim.
If necessorg, top with o wood block until the ponel
slips under the top trim piece.
Reossemble the bottom trim. Tighten the screws.
Adjust the hinge spring to occommodote the ponel
weight, if necessorg.
17