User Manual

58
Advance planning for professional hoods
ZV30RSFSS
ZV48TSFSS
ZV48SSFSS
Tapered-sided hood dimensions
Straight-sided hood dimensions
717Dia5
18"
40"
25" 47-15/16"
12"
18"
47-15/16"
47-15/16"
12"
25"
605Dia132
ZV48RSFSS
Restaurant-style hood dimensions
47-15/16"
47-15/16"
10"
25"
12"
22-1/2"
605Dia138
ZV36RSFSS
12"
22-1/2"
605Dia139
35-15/16"
35-15/16"
25"
10"
12"
22-1/2"
605Dia140
29-15/16"
29-15/16"
25"
10"
ZV36TSFSS
ZV36SSFSS
717Dia6
18"
28"
25"
35-15/16"
12"
18"
35-15/16"
35-15/16"
12"
25"
605Dia133
ZV30TSFSS
ZV30SSFSS
717Dia7
18"
22"
25"
29-15/16"
12"
605Dia136
18"
29-15/16"
29-15/16"
12"
25"
Model ZV54ISHSS supplied duct cover
dimensions: 20-1/4"W x 12"D x 5"H
Model ZV42ISHSS supplied duct cover
dimensions: 16"W x 12"D x 9"H
* 9" for ceiling heights of 7'11" to 8'5" using the
supplied support frame and duct cover
Island hood dimensions
ZV30HSRSS
with louvered riser
30"
12"
10-1/2"
3-1/2"
Under-cabinet hood dimensions
24"
16"
33"
36-1/4"
54"
5"*
*5" for ceiling heights of 7’11" to 8’5"
using the supplied support frame and duct cover
20"
14"
25-3/4"
31-3/
4"
42"
9"*
*9" for ceiling heights of 7’11" to 8’5"
using the supplied support frame and duct cover
Island hoods
These vent hoods are equipped for 10" round rigid metal duct.
Maximum equivalent duct length is 150 ft. Install a roof cap
with damper at the exterior opening.
Electrical requirements
These vent hoods must be supplied with 120V, 60Hz, and
connected to an individual, properly grounded branch circuit
protected by a 15- or 20-amp circuit breaker or time-delay fuse.
• On wall-mounted hoods, the back side is recessed, providing
a large area for the house wiring to exit the wall and be routed
to the rear knockout and junction box.
• The exact location for the house wiring depends on the
installation height and size of the hood. See installation
instructions for details.
• On wall-mounted hoods, the junction box is fastened to the
back of the hood on the right side. If necessary, the junction
box can be relocated to the top of the hood.
• On island hoods, the junction box is located on the top of the
hood and is concealed by ductwork.