Manual

11
09740-09.2013-DGbFITr
D
GB
F
I
TR
4| Compressor assembly
4.1 Setting up
4.2 Maximum permissible inclination
A
max.30°,
max.2minutes
a
max.15°,
continuous
operation
ATTENTION! Poor lubrication can damage the compressor.
Respect the stated values.
INFO! Newcompressorsarefactory-lledwithinertgas(3barnitrogen).
Leave this service charge in the compressor for as long as
possible and prevent the ingress of air.
Check the compressor for transport damage before
starting any work.
Fig.8
A
A
a
a
A
A
a
a
 Fittings(e.g.pipeholders,additionalunitsetc.)onthecompressorarepermissibleonly
followingconsultationwithBock.
 Setuponanevensurfaceorframewithsufcientload-bearingcapacity.Thecompressorcan
befastenedasfollows:
 -usingthe4drillholesonthebaseplate
 -usingthe3sideM10tappedblindholesontheleftorrightofthecompressorhousing
 -usingthe4M10tappedblindholesonthefrontofthecompressorhousing.
 Correctsetupofthecompressorandmountingofthebeltdrivearedecisiveforrunning
comfort,operatingsafetyandtheservicelifeofthecompressor.