user manual

Page 17SKU 65044
66164
For technical questions, please call 1-800-444-3353.
FIGURE G - LUBRICATION POINTS
OIL GAUGE
OIL FILL CAP
lubricating oil (30 weight) through
the Oil Fill Cap until the oil level is at
the red line on the Oil Gauge. Dis-
pose of waste oil properly, and in
accordance with local regulations. If
during operation the oil is below
the red line, immediately stop ma-
chining and add oil until the level
is at the red line.
(See Figure G.)
Refer to the following illustration for c.
instructions on overall lubrication of
the Lathe. Check before each use
to ensure the machine is properly
lubricated. (See Figure G.)
AFTER USE,4. clean external surfaces
of the tool with a clean cloth.
WARNING! If the Power Cord (111A)
of this Lathe is damaged, it must be
replaced only by a qualied service
technician.