user manual

Page 7SKU 65044
66164
For technical questions, please call 1-800-444-3353.
1. This tool is intended for use on a
circuit that has an outlet that looks
like the one illustrated above in 250
V~ 3-Prong Plug and Outlet. The
tool has a grounding plug that looks
like the plug illustrated above in 250
V~ 3-Prong Plug and Outlet. Make
sure the tool is connected to an outlet
having the same conguration as
the plug. No adapter is available or
should be used with this tool. If the
tool must be reconnected for use
on a different type of electric circuit,
the reconnection should be made by
qualied service personnel; and after
reconnection, the tool should comply
with all local codes and ordinances.
The 250 V~ plug does not come pre-2.
installed and will need to be installed
by a certied electrician.
The plug above is for use on a 15 A 3.
circuit. A different 250 V~ plug and
outlet combination may be used, pro-
vided it is rated to handle the electri-
cal requirements of the tool and is
installed by a certied electrician.
125 V~ REWIRING
Only a qualied electrician should 1.
rewire this lathe to operate on 125 V~
power.
Refer to Wiring Diagrams at end of 2.
manual.