Operation Manual

INSTRUCTIONS FOR ASSEMBLY AND USE

Tubular Drive Control

DC2-ECO - SL 433 MHz

The DC2-ECO is a modern and safe alternative to traditional Tubular

Drive key-switches that have to be hard wired.

To open or close a roller-shutter only the correct button on the hand

transmitter or the indoor keypad has to be pressed.

The most important characteristics of the DC2-ECO are:

➢ economic installation

➢ easy to use and programme

➢ water proof housings - IP 54

➢ A maximum of security through:

➢ transmission of a different unpredictable signal every time (Hopping Code)

➢ up to 100 million different coding possibilities

Technical Data:

240 V series

Supply voltage * 240 V AC 50 Hz 2,3 VA

Outputs 1 &. 2 1 x NO, NC relay contact,

isolated,10 A 250 V

Output 3 1 x NO, NC relay contact,

isolated, 5 A 250 V

Wiring 1.5 mm

max.,

Operating- -20 ˚C to +60 ˚C

temperature

* Further voltage variations upon request

geba GmbH is released its obligations regarding the guarantee and product liability if - with-

out prior permission - the unit has been modified, or if the installation is not in accordance

with our instruction manual.

The installer is responsible for adherence to the EMC- and low voltage regulations.

industrial controls

Caution!

Using the DC2-ECO with an industrial door, you must install the corresponding

security components, if the doorpanel weight is > 15kg. Electrical connections

may be carried out by skilled electrical personnel only.

Please note that all the keypad units are battery powered. The normal battery

life is dependent on the frequency of use of the appliance. For safety reasons

we advise replacement of the keypad batteries every 6 months.

BA-DC2-ECO-GB 08.02.2002 16:27 Uhr Seite 1

PAGE 1
BA-DC2-ECO-GB 08.02.2002 16:27 Uhr Seite 1 ® ® 6 1 industrial controls industrial controls INSTRUCTIONS FOR ASSEMBLY AND USE Tubular Drive Control DC2-ECO - SL 433 MHz Caution! Using the DC2-ECO with an industrial door, you must install the corresponding security components, if the doorpanel weight is > 15kg. Electrical connections may be carried out by skilled electrical personnel only.
PAGE 2
BA-DC2-ECO-GB 08.02.2002 16:27 Uhr Seite 2 ® ® 2 5 industrial controls industrial controls Dear customer, Description of the Appliance The remote control that you have purchased is one of our highest quality technical products. We have taken the greatest care during manufacture to ensure that this microprocessor controlled encoder reaches you in faultless condition.
PAGE 3
BA-DC2-ECO-GB 08.02.2002 16:27 Uhr Seite 3 ® ® 4 3 industrial controls industrial controls Assembly and mounting of the indoor keypad: 1. Fix the battery holder to the wall using the two free corner holes (two holes have nuts inserted for mounting the keypad) Make sure that the hole in the battery compartment is at the bottom. 2. Remove the plastic front frame from the keypad by gently releasing the four latches at the rear with a screwdriver. 3.