Operation Manual

Instructions for Assembly and Use

DC2 ”S“

Electronic control for tubular drives

The DC2 ”S“ is a modern and safe alternative to conventional control gear. For ope-

ning or closing of the door the drive unit is activated through a handtransmitter

(radio control) or through a push-button on the housing.

After pushing of the push-button or the handtransmitter the door is triggered UP or

DOWN.

Technical Data:

Supply voltage 230 V AC 50 Hz

Output 2x relay contact, 5 A / 230 V

1x relay contact, 2 A / 230 V

1x supply Voltage 24V/50mA

Connections 1.5 mm

max.,

Ambient- -20 ˚C to +60 ˚C

temperature

geba GmbH is released of its obligations regarding guarantee and product liability if - without

prior permission - the unit has been modified, or if the installation is improper or not in accordance

with our instruction manual.

The installer has to take care that the EMC-regulations are respected.

The most important characteristics of the DC2 ”S“ are:

➢ Simple operation, programming and assembly.

➢ Water-protected enclosure.

➢ A maximum of safety:

➢ The electronic decoder is separately installed in the protected area

➢ Nearly unlimited data security, even with power failure

➢ Direct connection to safety edge

➢ Rolling code transmitter

➢ High switching capacity for direct control of appliances

24V / 50 mA output for lphoto beam

industrial controls

Service display

The 4 most likely faults are indicated by the service display lamp by means of a

simple flashing code system as below:

1x flash safety edge defect

2x flash limit switch not reached

or defect

3x flash pre-limit switch defect

steady glow safety edge activated

PAGE 1
® ® industrial controls industrial controls Service display The 4 most likely faults are indicated by the service display lamp by means of a simple flashing code system as below: Instructions for Assembly and Use DC2 ”S“ Electronic control for tubular drives 1x flash safety edge defect 2x flash 3x flash limit switch not reached or defect pre-limit switch defect The DC2 ”S“ is a modern and safe alternative to conventional control gear.
PAGE 2
® ® industrial controls industrial controls Dear customer, Description of the appliance The DC2 ”S“ which you have purchased is one of our highest quality technical products. We have taken the greatest care in its manufacture to ensure that this microprocessor controlled encoder reaches you in faultless condition. However in the unusual event of suspected equipment failure please return the appliance together with the enclosed warranty document to your dealer or direct to our factory.
PAGE 3
® ® industrial controls industrial controls Assembly Instructions Wiring diagram DC2 ”S“ Assembly of the logic unit (inside area): antenna DIPDIP SWITCH Schalter Antenne 1. Put the screw-driver into the gap of the enclosure front, push the screw-driver up and open the enclosure. 2. Remove the control PCB (which is force fitted to the inside of the enclosure). 3. Locate the screwed glands supplied (sealing nipple left side) in the enclosure and replace the PCB.