Operation Manual

Program 2
Clearing of a pass code
A pass code is cancelled by clearing of the corresponding memory
location (00-49)
In case of loss of the master code:
In case you forget the master code or the appliance has been accidently interfered with, there
is the possibility to reset the appliance by means of pressing the general reset button. This
means the appliance is brought back into the state preset by the factory.
Now the master code 12345678 preset by the factory as well as the pass code 1234 are valid
again. The appliance must now be re-programmed again.
Input 8-digit
master
code
Input of 2-digit
memory location,
e.g. 07 or 28
Sound
signal
2 x long
Sound
signal
1 x short
Sound
signal
1 x long
Push key
button
Push key
button
Push key
button
The memory location chosen is now cleared
Push key
button
2
Dear customer,
The Cody which you have purchased is one of our highest quality technical pro-
ducts. We have taken the greatest care in its manufacture to ensure that this
microprocessor controlled encoder reaches you in faultless condition. However in
the unusual event of suspected equipment failure please return the appliance
together with the enclosed warranty document to your dealer or direct to our
factory.
The extent of warranty exclusively refers to the free repair of malfunctions of the
appliance, which demonstrably are caused by faults in production or defective
material, inclusive of spare parts required for this purpose.
Therefore please first read the instructions of use carefully before you start
programming!!!
WARRANTY-DOCUMENT
On the below described encoder we grant a warranty of
1 year
Type: TCS - Cody 1/2
Serial number: see label on logic PCB
Serial master code: All appliances are supplied with master code 12345678
Pass code: All appliances are supplied with pass code 1234 on memory location 01
Production date: ____________________________________________________
Sales date: ____________________________________________________
Dealers adress: ____________________________________________________
____________________________________________________
____________________________________________________
Reset to factory-settings:
Hold the GENERAL RESET BUTTON - after several short
sound signals a long sound signal can be heard (~ 5 sec.).
industial controls
®
industial controls
®