Instructions / Assembly

13
Bowl installation
1 Remove yellow protection plugs and seals
from pipes.
2 Insert discharge pipe into the pipe hub in the
wall. Place a straight edge flush against the
wall and mark a line on the pipe. Fit finned
rubber seal onto flush pipe. Repeat same
procedure for discharge pipe.
3 Place discharge pipe with gasket into waste
outlet of bowl. Also place flush pipe with fin
gasket into inlet of bowl. Then mark a
second line on both pipes.
4 Add dimension X and 1/8". Using that
dimension, mark a line on the pipe
measuring from the hub side. Cut off the
pipe at the line with a pipe cutter.
5 Add dimension Y and 1/8". Using that
dimension, mark a line on the pipe
measuring from the hub side. Cut off the
pipe at the line with a pipe cutter.
6 Bevel the sharp edges as shown to assure a
smooth insertion into the pipe hubs in the
wall.
7 Install both seals into the pipes in the wall.
Lubricate seals with appropriate rubber seal
lubricant.
1
1
2
2
2
2
1
1
2
2
1
1
1
2
X
X
+
1
/8
"
+
(
3
m
m
)
Y
+
1
/8
"
+
(
3
m
m
)
Y
1
2
© 03-2021
968.075.00.0(02)