Safer Choice Standard

ManualsBrandsGeek Chef ManualsAppliances11-in-1 Multi-Function 6.3 Qt. Pressure Cooker with Glass Lid

谱尼测试集团深圳有限公司

深圳市南山区创业路中兴工业城六栋一层

测试报告（Test Report）报告编号(NO.)：MDCDFTCU64542504 日期(Date)：2016.12.20 Page 1 of 3

委托单位 Applicant：佛山市高明兆兴铝业有限公司

地址 Address：佛山市高明区杨和镇和顺路 16 号

委托单位提供样品信息如下：

The following sample(s) was/were submitted and identified on behalf of the client as：

样品名称 Sample Name：铝板

样品型号 Sample Model： 1100

样品接收日期 Sample Received Date： 2016.12.16

样品测试日期 Testing Period： 2016.12.16 TO 2016.12.20

参考要求： RoHS 2011/65/EU 及修订指令(EU)2015/863 附录Ⅱ的要求

Reference Requested： RoHS Directive 2011/65/EU & (EU)2015/863 Annex Ⅱ

参考方法：

Reference Method： (1) IEC62321-5 Edition 1.0:2013,用原子吸收光谱仪测定铅的含量

IEC62321-5 Edition 1.0:2013, Lead Analysis is performed by AAS

(2) IEC62321-5 Edition 1.0:2013,用原子吸收光谱仪测定镉的含量

IEC62321-5 Edition 1.0:2013,

Cadmium Analysis is performed by AAS

(3) IEC62321-4 Edition 1.0:2013,

用电感耦合等离子体原子发射光谱仪测定汞的含量

IEC62321-4 Edition 1.0:2013,

Mercury Analysis is performed by ICP-OES

(4) IEC62321 Edition 1.0 :2008,

用点测试法/沸水萃取法测定六价铬的含量

IEC62321 Edition 1.0 :2008,

Hexavalent Chromium Analysis is performed by Spot-test/

Boiling-water-extraction Method

测试结果 Testing Results：请参见下页 Please refer to next page(s)

编制人 Edited by：

审核人 Checked by：

批准人 Approved by：

Code：n281x92k

Summary of content (8 pages)

PAGE 1
测试报告（Test Report）报告编号(NO.)：MDCDFTCU64542504 委托单位 Applicant：地址 Address：日期(Date)：2016.12.20 Page 1 of 3 佛山市高明兆兴铝业有限公司佛山市高明区杨和镇和顺路 16 号委托单位提供样品信息如下： The following sample(s) was/were submitted and identified on behalf of the client as：样品名称 Sample Name：铝板样品型号 Sample Model： 1100 样品接收日期 Sample Received Date：样品测试日期 Testing Period： 2016.12.16 2016.12.16 TO 2016.12.
PAGE 2
测试报告（Test Report）报告编号(NO.)：MDCDFTCU64542504 测试结果 Test Results (Unit：mg/kg) 测试项目 Test Item 铅(Lead) 日期(Date)：2016.12.20 Page 2 of 3 方法检出限 MDL 1 测试结果 Test Result 19.8 RoHS 限量 RoHS Limit 1000 镉(Cadmium) 1 未检出（N.D.） 100 汞(Mercury) 1 参见备注(6) See Note (6) 未检出（N.D.） 1000 阴性(Negative) —— 六价铬(Hexavalent Chromium) 备注 Note： (1) mg/kg = ppm (2) “—” = 未规定 Does not stipulate (3) N.D.
PAGE 3
测试报告（Test Report）报告编号(NO.)：MDCDFTCU64542504 日期(Date)：2016.12.20 Page 3 of 3 测试流程图 Measurement Flow-chart 测试人员Tested By：梁英玲审核人Checked by：杨新实验室负责人Person in charge of the lab by：赵彦远样品按照下述流程被完全消解（六价铬除外）。 These Samples Were Dissolved Totally By Pre-conditioning Method According To Below Flow Chart.
PAGE 4
Test Report Number：LCZC16050450-E Date：May. 18, 2016 Page 1 of 5 Applicant ： Fo Shan Shun de Le liu Li quan Hardware Factory Address ： Loosen One of Seven Road No.1, Longsheng, Longyan Industrial Zone, Leliu, Shunde District, Foshan City Date of Received ： May. 13, 2016 Testing Period ： From May. 13, 2016 to May. 18, 2016 Report on the submitted sample said to be： Item Name ： Measuring cups, Spoons, Spoon, Steamer rack Material ： PP Sample No.
PAGE 5
Test Report 1 Number：LCZC16050450-E Date：May. 18, 2016 Page 2 of 5 TEST RESULT 1.
PAGE 6
Test Report Number：LCZC16050450-E Date：May.
PAGE 7
Test Report Number：LCZC16050450-E Date：May. 18, 2016 Page 4 of 5 C.
PAGE 8
Test Report Number：LCZC16050450-E Date：May. 18, 2016 Page 5 of 5 As described in the above component description(s) and showed in the above picture(s), the relevant compositive samples (01, 02) were analyzed with equal weight of each sample. ********************************************************************************************************************************* *LCZC16050450* End of Report This test report shall not be reproduced except in full, without written approval of LCTECH.