User Guide

[e-mail]
3. How to connect? (For Jetson Nano 2GB, please refer to B01 )
Supplement for Rev A02: The blue wire =>3.3V pin at J41; White wire => GND pin at J41
4. About cooling fan
The case is reserve 22mm high fan installation height , it is recommend to use Noctua NF-A4x20 5V PWM fan, we prepare 4pcs PM2.5*22 screws and 4pcs
M2.5 nuts and 4 pcs gaskets to install this fan. You need to use the ABS tweezers when you install this fan.
5. About camera bracket (NEW)
We provide a new camera bracket to setup the camera although you can also mount the camera on the rear panel of the case. Since we don't know the
camera you are using, so this bracket hole is only compatible with the size of the Raspberry Pi official camera.You are free to choose where the camera bracket
is installed.