User's Manual

11
When it is connected to
the power adaptor or it
has been installed 4
batteries, bell rings
normally, or camera
LED blinks normally,
when there is an
incoming call, the
shaker doesn’t vibrate.
1) Check if it is connected
to the shaker correctly.
2) Check if the shaker
socket has been
damaged.
3) Check if the alarm
mode selection switch
position is correct.
If the AmpliCALL20
does not ring when the
doorbell is pressed
1) Check that the red light
on the doorbell flashes
when it is pressed. If it
does not, change the
battery.
2) Register the doorbell to
the AmpliCALL20 again
3) Make sure the alarm
configuration button is
not on "0"
INSTALLATION