User's Manual

Setting up Door bell

1. The Door Bell can be take with the people who need

the assistance.

2. The door bell can be fixed on the wall or door

surround, drill two holes horizontally, 15mm apart,

put the supplied anchor into the two holes, hang the

door bell on to the two anchors and then instert and

tighten screws, and then stick the blank sticker on the

two holes.

3. The door be can be stick onto a door, window using

the supplied strong adhesive tape. Remove the

protective paper from the adhesive tape on the back

of the door bell and stick to the required window.

INSTALLATION

Setting UP Indoor unit

Wall Mounting

1. Drill two holes horizontally, 96mm apart, and leave the

screws protruding from the wall by 5mm.

2. Hang the base on to the two screws and pull the base

down to lock it on

Table Mounting

If you want to mount the unit on the table, only put it into

the base cradle, and then place the base cradle on the

table.

Setting The Alarm Mode

Choose which alarm mode you want to by moving the

alarm mode switch to one of the following position:

0 : no alarm

: both strobe flasher and sound alarm activated

: both strobe flasher and shaker (if connected)

activated

: both sound alarm and shaker (if connected)

activated

Volume Control Slide Switch

Use the slider control to adjust the volume of door bell

ring and phone ring or power OFF.

INSTALLATION