Operation Manual

20
Remote Control
Remote Control Commands
When you remotely listen to messages for longer than 2 minutes and 30
seconds, you will hear a tone and you then need to press any key on your
telephone to continue the playback of the messages.
ANSWERING MACHINE
Call the answering machine (using your telephone number)
When you have finished accessing the machine replace the handset.
While the outgoing message is playing, enter the remote code. If the
code is accepted you will hear two beeps
Select a remote control command (within 20 seconds) from the list
below
Command Functions
25
2#
During Playback
3#
6#
7#
8#
##
After Playback
3#
7#
8#
9#
0#
Play new messages
Play all messages
Erase single message during playback
Skip to previous message
Skip to next message
Repeat message
Stop playback
Erase all messages
Record a new outgoing message, to stop recording
press 7# again
Record a MEMO, to stop recording press 8# again
Turn the answering machine either On or Off. Three
beeps indicate Off- Two beeps indicate On
Room monitor, press 5# to stop the room monitoring