CL100 English
!!!User manual to read carefully before start to use!!! !!!Manuel d’utilisation à lire impérativement avant la mise en service!!! !!! Bevor Ihr neues Telefongerät zu benutzen, bitte lesen Sie dies Benutzerhandbuch sehr sorgfältig!!! CAUTION: this telephone is specifically designed for the people with hearing difficulties and is provided with a handset earpiece volume control for individual requirements.
Index Description 4 Setting up - Connecting the telephone - Ringer volume setting - Tone/Pulse switch - Time breack recall setting - Wall mounting 7 7 7 8 8 8 Volume and tone adjustment - Receiving volume and tone adjustment - Sending volume adjustment 10 10 12 Using the phone - Answer a call - Making a call - Last number redial - Recall, * & # buttons - Mute button - Storing telephone numbers - Dialling stored number 13 13 13 14 14 14 15 16 General informations 17 3
Description 3 emergency numbers Reception volume adjustment Reception tone adjustment Red light of tone/ volume activation Extra volume and tone adjustment Clip for wall mounting Direct memories Handset cord socket Last number redial Mute Memory storing Time break recall Flashing incoming ring indicator 4
Description Holes for wall mounting Memo card Time break recall Dialling mode Pulse/Tone Battery compartment 5 Handset cord socket
Description Ring volume setting Volume and tone adjustment ON/OFF switch 6 Sending volume setting Line socket
Setting up - Connect the handset cord. - Open the battery compartment. - Insert 4 alkaline batteries (type AAA 1.5V, not supplied) in the compartment (*). Batteries are required if you wish to increase the ringer level up to 10 dB. - Snap the battery door back in place. - Connect the line cord plug into the line socket on the rear of the unit (*). - Connect the other end of the line cord into the wall PTT socket (*).
Setting up 3 - Dialling mode (Tone/Pulse) settings The Tone/Pulse switch is factory pre-set to Tone position. In the UK,all telephone exchanges now use Tone (T) dialing.If your phone does not dial out, it is probably being used from an older private switch board (PBX).In this case,the Tone/Pulse switch must be changed to Pulse (P). 4 - Time Break Recall setting (270/100) Your phone works with a time break recall for United Kingdom (R=100ms). It can be switched to 270ms for other locations or PBX’s.
Setting up Drill 2 holes in the wall (80mm apart). Insert the wall plugs and the screws leaving about 6 mm of the screws projecting from the wall. Slide the telephone downwards to secure.
Volume and tone adjustment 1 - Receiving volume and tone adjustment You can increase the volume and adjust the receiving tone according to your own hearing requirements. The button allows extra receiving and tone functions to be activated or not during the conversation. When the function is activated, the red light of extra receiving and tone function located near the button is lit. Adjust the TONE and VOLUME buttons to fit the levels to your own hearing requirements.
Volume and tone adjustment TONE Bass +10db max Treble +10db max Normal Note: When the tone (treble), earpiece volume and sending levels are set to the maximum, whistling may occur. Then the sending level settings should be decreased with the switch . When the switch located behind the phone is ON, the extra-receiving and tone functions are automatically activated each time you use the phone. When this switch is OFF, you will need to activate the function by pressing the button .
Volume and tone adjustment 2 - Sending volume adjustment If your voice is quiet or called parties have difficulty hearing you, you can increase the sending level volume with the switch located on the right side. You can also decrease the sending volume if required.
Using the phone If you are using this telephone with a hearing aid, set your hearing aid to the “T” setting. 1 - Answer a call - When an incoming call is received the phone will ring and flash, to answer the call lift the handset and speak. - On completion of the call, carefully replace the handset in the cradle to release the line. 2 - Making a call - Lift the handset. - Await the dial tone and dial required number. - On completion of the call,carefully replace the handset in the cradle.
Using the phone 3 - Last number redial - Lift the handset. - Await the dial tone and press button. -The previously dialled number will be automaticaly redialled (not in use for memory numbers). 4 - Recall (R), * & # buttons These are used with the new services provided on digital exchanges. For details please contact your network operator. 5 - Mute button If you wish to speak privately to someone else in the room without your caller overhearing, press and hold the button.
Using the phone 6 - Storing telephone numbers Your telephone can store12 direct memories including 3 priority numbers (24 digits maximum for priority memory and 32 digits for M1, M2...M9). For example, the 3 priority P1, P2, P3 memories allow you to store the 3 numbers below: P1=Fire P2=Police P3=Doctor To store a number please follow instructions below: - Lift the handset. - Press button. - Dial the number. - Press button. - Press M1, M2, ..., or M9 or one of 3 priority memories to store your number.
Using the phone 7 - Dialing stored numbers - Lift the handset and await the dial tone. - Press appropriate button M1, M2, ..., or M9 or one of 3 priority memories, the stored number will be dialled automatically. To register your stored phones numbers, use the index located under the base.
General informations Recycling directives: The WEEE (Waste Electrical and Electronic Equipment) has been put in place for the products in end of life are recycled in the best way. When this product is out of order, please do not put it in your domestic waste bin. Please use one of the following disposal options : - Remove the batteries and deposit them in an appropriate WEEE skip. Deposit the product in in a appropriate WEEE skip. - Or hand the old product to the retailer.
UGCL100V2_Ver:03 United Kingdom 5 Swallow Court Swallowfields Welwyn Garden City Hertfordshire, AL7 1SB For product support: 01707 384438 www.geemarc.com FRANCE Parc de l’Etoile 2, rue Galilée BP20061 59791 Grande Synthe CEDEX Tél. service après vente : 03 28 58 75 99 www.geemarc.com Deutschland Siemensstrasse 10, 53121 Bonn Germany Tel: +49(0)228/ 74 87 09 0 Fax: +49(0)228/ 74 87 09 20 www.geemarc.
