Operation Manual

Setting Up

The telephone requires four good quality AAA batteries. These

are not supplied with your telephone. Carefully remove the

battery compartment cover-found on the underside of the

telephone base. Check the battery polarity diagrams when

inserting the batteries. Fit the battery cover back on.

Connect one end of the curly cord to the handset. The other end

of the curly cord plugs into the jack on the left hand side of the

PHOTOPHONE 300 unit marked . Place the handset on the

cradle.

Connect the line cord to the socket located at rear of telephone

then connect the plug into the wall socket**.

For the LCD display, backlight and other special features you

must insert the power adapter (batteries act as a backup in case

of power failure). Connect the power adaptor to the jack located

at the rear of the telephone marked DC9V then plug the other

end into a 13amp wall socket (*). Please choose a socket near

your telephone to enable you to unplug the mains power quickly in

case of a problem.

(*) Classified “hazardous voltage” according to EN60950 standard

(**) Classified TNV-3 according to EN60950 standard.

INSTALLATION