Installation Guide

1918

Troubleshooting

System Requirements

Technical Specications

Cannot connect to your Wi-Fi network:

Make sure you entered the correct Wi-Fi password during the Wi-Fi

setup. Check whether there are any Internet connection problems. If the

Wi-Fi signal is too weak, reset your Wi-Fi router and try again.

• Mobile device running iOS

9 or higher or Android™ 5.0 or higher

• Existing Wi-Fi Network

• Camera: up to 1080p (1920x1080P)

at 10 frames / sec. H.264 encoding

• Field of View: 95˚

• Weatherproof: IP66

• Storage: supports up to 128gb

microSD card (16GB microSD card

is included, and is replaceable)

• Wi-Fi: IEEE 802.11 B/G/N, 2.4GHz

(not compatible with 5GHz Wi-Fi networks)

FCC Notice:

This equipment has been tested and found to comply with the limits for a Class B digital device,

pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection

against harmful interference in a residential installation. This equipment generates, uses and can

radiate radio frequency energy and, if not installed and used in accordance with the instructions, may

cause harmful interference to radio communications. However, there is no guarantee that interference

will not occur in a particular installation. If this equipment does cause harmful interference to radio

or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

• Reorient or relocate the receiving antenna.

• Increase the separation between the equipment and receiver.

• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

• Consult the dealer or an experienced radio/TV technician for help.

Caution: Any changes or modiﬁcations to this device not explicitly approved by manufacturer could void

your authority to operate this equipment.

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:

(1) This device may not cause harmful interference, and (2) this device must accept any interference

received, including interference that may cause undesired operation.

The device has been evaluated to meet general RF exposure requirement. The device can be used in

portable exposure condition without restriction.