Installation Guide

54
Blinking
Ready to connect
Solid
Connected
STEP 3.
Login to the App.
3 Plug In.
How do I reset my device?
A reset button is located on the cord connected to the camera. Reset the
camera by holding down the button for several seconds.
Important: Set up and connect the camera before mounting. Set up works
best near your home router. If the camera is disconnected from power after
setup, it will automatically reconnect when plugged in again.
Note: The camera will appear inactive while booting up—allow two minutes
for the light to activate.
What does the blinking light mean?
2 Login to the Geeni App.
Reset
Button
Connected
to Camera