1:5 Splitter For HDMI 1.3 User Manual

ManualsBrandsGefen ManualsNetwork Router1:5 Splitter For HDMI 1.3 EXT-HDMI1.3-145

1:5 Splitter For

HDMI 1.3

Model #EXT-HDMI1.3-145

USER MANUAL

www.gefen.com

Summary of content (8 pages)

PAGE 1
:5 Splitter For HDMI 1.3 Model #EXT-HDMI1.3-145 USER MANUAL www.gefen.
PAGE 2
ASKING FOR ASSISTANCE Technical Support: Telephone Fax (818) 772-9100 (800) 545-6900 (818) 772-9120 Technical Support Hours: 8:00 AM to 5:00 PM Monday through Friday. Write To: Gefen Inc. c/o Customer Service 20600 Nordhoff Street Chatsworth, CA 91311 www.gefen.com support@gefen.com Notice Gefen Inc. reserves the right to make changes in the hardware, packaging and any accompanying documentation without prior written notice. 1:5 Splitter For HDMI 1.3 is a trademark of Gefen Inc.
PAGE 3
TABLE OF CONTENTS 1. Introduction 2. Features 3. Panel Descriptions 4. Connecting and Operating the 1:5 Splitter for HDMI 1.3 5. Specifications 6.
PAGE 4
INTRODUCTION The Gefen 1:5 Splitter for HDMI 1.3 allows set-top boxes, DVD players, Bluray players and other HDTV devices with HDMI outputs to be connected to up to five HDTV displays (or more if multiple splitters are utilized in place of HDTV displays How It Works The 1:5 Splitter for HDMI 1.3 is a distribution hub that sends the same HDMI signals to up to five HDTV digital displays. You simply connect your HDMI video source to the 1:5 HDMI 1.
PAGE 5
FEATURES Features • Lip-Sync Pass Through • 225 MHz (up to 12 bit YUV 444 supported @ 1080p) • Deep Color Supported (XV Color Supported) • Color Space Conversion Supported • Dolby Tru-HD & DTS Master Supported • CEC Pass Through Includes: (1) (1) (1) (1) (1) 1:5 Splitter for HDMI 1.
PAGE 6
EDID Switch HDMI Input HDMI Output 1-10 Connects to 24VDC power supply Reset Power LED & Act.
PAGE 7
CONNECTING AND OPERATING THE 1:5 SPLITTER FOR HDMI 1.3 How to Connect the 1:5 Splitter for HDMI 1.3 to your devices 1. Connect the supplied cable from the HDTV HDMI source into the 1:5 Splitter for HDMI 1.3 input. 2. Connect the cables from your displays (monitor or projector) into the HDMI outs of the 1:5 Splitter for HDMI 1.3. 3. Plug the 24VDC power supply into the 1:5 Splitter for HDMI 1.3. NOTE: Display information from the display connected to HDMI output port 1 is sent back to the source.
PAGE 8
SPECIFICATIONS Video Amplifier Bandwidth.................................................................225 MHz Input Video Signal........................................................................1.2 volts p-p Input DDC Signal...................................................................5 volts p-p (TTL) Single Link Range.............................................................1080p/1920 x 1200 HDMI Connector..............................................................