User manual

9
USING THE IR REMOTE CONTROL UNIT
IR Remote Control Key Mapping
Each input and output on the 4x4 VGA Matrix is represented by a button on the IR
Remote Control unit. The table below lists the corresponding inputs and outputs.
Routing Sources using the IR Remote Control unit
Issuing a routing command is a two step process. The fi rst step is to select the
monitor where the source will be routed. The second step is to select the source.
Example 1
Route the source device connected to In 7 to the monitor connected to Out 3.
1. Press button 3 (monitor 3) on the IR remote control unit.
2. Press button 7 (source 7) on the IR remote control unit.
The source connected to In 7 will be routed to the monitor connected to Out 3.
Example 2
Route the source device connected to In 1 to the monitor connected to Out 1.
1. Press button 1 (monitor 1) on the IR remote control unit.
2. Press button 1 (source 1) on the IR remote control unit.
The source connected to In 1 will be routed to the monitor connected to Out 1.
RMT-16-IR
Button
Source Output
111
221
331
441
512
622
732
842
RMT-16-IR
Button
Source Output
913
10 2 3
11 3 3
12 4 3
13 1 4
14 2 4
15 3 4
16 4 4