User manual

9
CONFIGURING THE CAT5-5600HD
Adjusting the Signal Quality
The CAT5-5600HD has two EQ trim pots on the front of the Receiver Unit to
compensate for the extension distance and cable skew found in different CAT-5e /
CAT-6a cabling brands. EQ 1 corresponds to DVI 1 and EQ 2 corresponds to DVI
2. If there is no output video or if output video contains video artifacts and/or video
noise such as snow, use the steps below to adjust the EQ trim pot(s).
1. Insert a small fl at-headed tool into the EQ trim pot on the front panel of the
Receiver Unit.
2. The trim pot has 8 set positions. Turn the trim pot clockwise until it clicks into
the next position. Continue adjusting the trim pot until the issue is resolved.
3. Carefully remove the adjustment tool.
EQ Trim Pot