User manual

CONNECTING AND OPERATING THE DVI 1500

How To Connect The DVI 1500

1. Connect the DVI source device to the DVI 1500 sender unit using the supplied

DVI cable.

2. Connect a user supplied CAT-5, CAT-5e or CAT-6 cable to the sender unit.

3. Connect four user supplied multi-mode LC-LC terminated ﬁ ber optic cables

into the DVI 1500 sender unit.

NOTE: 50 or 62.5 micron multi-mode ﬁ ber optic cable is required for correct

operation.

4. Connect the other end of the CAT-5, CAT-5e or CAT-6 cable into the DVI

1500 receiver unit.

5. Connect the other ends of all four multi-mode LC-LC terminated ﬁ ber optic

cables into the DVI 1500 receiver unit.

NOTE: Please take careful note of the labeling above each ﬁ ber optic port on

both the sending and receiving DVI 1500 units. The most common user error is

to mis-match the ﬁ ber optic cable connections on each end, which results in no

video being transmitted.\

6. Connect the included 5V DC power supplies into both sender and receiver.

7. Power on the display, then the source.

No further adjustments are necessary to operate the DVI 1500.

EXT-DVI-1500HD

Sender

Receiver

Computer

DVI Monitor

DVI CABLE

CAT-5 CABLE

4X FIBER OPTIC LC-LC CABLE

(Up To 1,640 FT, 330 FT w/HDCP)

(Up To 1,640 FT )