User manual

26
RS-232 CONTROL
RS232 Settings
Bitspersecond............................................................................................................19200
Databits...............................................................................................................................8
Parity .............................................................................................................. None
Stop bits ................................................................................................................1
FlowControl...................................................................................................................None
5 4 3 2 1
9 8 7 6
1 2 3 4 5
6 7 8 9
Only Pins 2 (RX), 3 (TX), and 5 (Ground) are used on the RS-232 serial interface
NOTE:Thereturnvaluewillbedisplayedwhenusingaterminal-
basedapplication,indicatingthecurrentvalueafterexecutingthe
command.
IMPORTANT: WhensendingRS-232commands,acarriage return
andaline feed charactermustbeincludedattheendofeachline.
Telnet/CommandNamesarecase-sensitive.