User manual

27
IP CONFIGURATION
Conguring the IP Address
The32x32 DVI MatrixsupportsIP-basedcontrolusingTelnetorthebuilt-inWeb-based
GUI.TosetupIPcontrol,thenetworksettingsforthe32x32 DVI Matrix mustbecongured
viaRS-232.Thedefaultnetworksettingsforthematrixareasfollows:
IPAddress: 192.168.1.72
Subnet:  255.255.255.0
Gateway:192.168.1.254
HTTPPort: 80
TelnetPort: 23
1. ConnectanRS-232cablefromthePCtothe32x32 DVI Matrix.
2. Launchaterminalemulationprogram(e.g.HyperTerminal)andusethefollowing
settings:

BaudRate:  19200
DataBits:  8
Parity:  None
StopBits:  1
FlowControl:  None







3. SettheIPaddressforthematrixusingthe#sipaddcommand(seepage
45fordetails).
4. Setthesubnetmaskusingthe#snetmaskcommand(seepage46fordetails).
5. Setthegateway(router)IPaddressusingthe#sgatewaycommand
(seepage43fordetails).
6. SettheTelnetlisteningportusingthe#set_telnet_portcommand
(seepage42fordetails).
7. SettheHTTPlisteningportusingthe#set_http_portcommand
(seepage40fordetails).
8. Power-cyclethematrixtorebootandcompleteallIPsettingchanges.
9. TypetheIPaddressthatwasspeciedinstep3,inawebbrowsertoaccesstheWeb
GUIorusethesameIPaddresstoTelnettothematrix.
NOTE:Dependinguponthenetwork,theIPaddress,subnetmask,
gatewayIP,Telnetport,andHTTPportwillneedtobeset.Consult
yournetworkadministratortoobtainthepropersettings.