User manual

37
RS-232 / TELNET COMMANDS
IP Conguration
Command Description
#display_telnet_welcome Enable/disabletheTelnetwelcomemessageonlogin
#ipcong DisplaysthecurrentIPconguration
#resetip ResetstheIPcongurationtofactorydefaults
#set_http_port SetstheHTTPlisteningport
#set_telnet_pass SetstheTelnetpassword
#set_telnet_port SetstheTelnetlisteningport
#set_telnet_username SetstheTelnetusername
#sgateway SetstheIP(router)gateway
#show_telnet_pass DisplaystheTelnetpassword
#show_telnet_username DisplaystheTelnetusername
#sipadd SetstheIPAddress
#snetmask SetstheIPsubnetmaskvalue
#use_telnet_pass Enables/disablestheTelnetpasswordonlogin
#display_telnet_welcome Command
Enables/disablestheTelnetwelcomemessageonlogin.
Syntax:
#display_telnet_welcome

Parameters:
param1   Telnetwelcomemessagestate [0-1]
Value Meaning
0 Off
1 On
Examples:
#display_telnet_welcome 0
Telnet welcome at login is set to OFF
#display_telnet_welcome 1
Telnet welcome at login is set to ON