User manual

54
RS-232 / TELNET COMMANDS
r Command
Thercommandroutesthespeciedinputtothedesignatedoutput(s).


Syntax:
r param1[...param9]


Parameters:
None
Notes:
Unlikeothercommands,donotprecedethercommandwiththe“#’symbol.
Ifparam2 = 0,thenthespeciedinputwillberoutedtoalloutputs(alsorefertothescom-
mandonthenextpage).Ifmorethaneightinputsneedtobespecied,thenther com-
mandmustbeexecutedtwice.
Examples:
r 1 2
Input 1 is routed to outputs: 2
Routing Input 1 to Output 2
r 1 4 5 6 7 9 10
Input 1 is routed to outputs: 4 5 6 7 9 10
Routing Input 1 to Output 4
Routing Input 1 to Output 5
Routing Input 1 to Output 6
Routing Input 1 to Output 7
Routing Input 1 to Output 9
Routing Input 1 to Output 10
r 1 0
All outputs are routed to input 1
Routing Input 1 to all Outputs