User manual

66
RS-232 / TELNET COMMANDS
f Command
Thefcommandenables/disables5Vontheinput.Thefcommandcanalsobeused
withoutparameterstoreturnthestateofeachinput.“ON”isreturnedif+5Visenabledon
theDVIinput.“OFF”isreturnedif+5VisdisabledontheDVIinput.
Syntax:
f param1 param2


Parameters:
param1   Input    [1-32]
param2   State    [0-1]
State Meaning
0 Disable
1 Enable
Notes:
Thefcommandcanalsobeusedwithoutparameterstoreturnthestateofeachinput.
“ON”isreturnedif+5VisenabledontheDVIinput.“OFF”isreturnedif+5Visdisabledon
theDVIinput.
Examples:
f 5 1
Turn on FO input 5
f
FO inputs status table
Board | +0 | +1 | +2 | +3 | +4 | +5 | +6 | +7
1 | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF
2 | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF
3 | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF
4 | OFF | OFF | OFF | OFF | OFF | OFF | OFF | OFF