User manual

1. Remove battery cover from the back of the included RMT-SHDS-IR remote.

2. Verify that DIP switches 1 and 2 are in the down (OFF) position. (See page 9

for DIP Switch IR Channel Settings.)

3. Insert the battery, holding the battery so that you can see the positive side

facing up. The side that is not marked must be facing down.

4. Test the RMT-8HDS-IR remote by pressing ONLY one button at a time. The

indicator light on the remote will ﬂ ash once each time you press a button.

NOTE: The RMT-8HDS-IR ships with two batteries. Only one battery is required

for operation, the other battery is complimentary.

IR REMOTE INSTALLATION

Battery chamber

DIP switch bank