User manual

36
RS-232 SERIAL COMMANDS
TREB Command
The TREB command sets the treble subwoofer volume.
Syntax:
TREB param1
Parameters:
param1 Level [-12...12]
Notes:
The + or - character can also be used, instead of specifying a value, in order to
increase or decrease the treble level by 1 dB intervals.
Use ? for param1 to retrieve the current value.
VOL Command
The VOL sets the overall output audio signal.
Syntax:
VOL param1
Parameters:
param1 Value [-81...12]
Notes:
The + or - character can also be used, in place of specifying a value, to increase
or decrease the output volume by 1 dB intervals.
Use ? for param1 to retrieve the current value.