User manual

37
General Commands
Command Description
IR Sets the IR channel
OSDHPOS Sets the horizontal position of the OSD
OSDVPOS Sets the vertical position of the OSD
POWER Turns the Scaler ON or OFF
IR Command
The IR command sets the IR Channel used by the Scaler. The IR channel can
be set to 1, 2, 3, or 4.
Syntax:
IR param1
Parameters:
param1 Level [1...4]
Notes:
Set param1 to ALL to have the Scaler receive on any IR channel.
Use ? for param1 to retrieve the current value.
OSDHPOS Command
The OSDHPOS command sets the horizontal position of the OSD.
Syntax:
OSDHPOS param1
Parameters:
param1 HPos [0...100]
Notes:
Use ? for param1 to retrieve the current value.
RS-232 SERIAL COMMANDS