User manual

CONNECTING THE DIGITAL AUDIO EXTENDER

How to Connect the Digital Audio Extender System:

1- Connect your digital audio source’s outputs to the Digital Audio Extender sender

unit’s audio inputs with either TOSLINK or S/PDIF cabling. Please see “Panel

Layout” on page 4 for a list of connectors on the units.

2- Connect the Sender and Receiver units to one another on their RJ45 link connec-

tor jacks using a single CAT5 cable.

3- Connect your digital audio receiver or digital audio speaker system to the Digital

Audio Extender receiver unit using a TOSLINK or S/PDIF cable plugged into either

one of or both S/PDIF or TOSLINK outputs on the receiver unit. The receiver unit

can output TOSLINK and S/PDIF signals simultaneously.

4- Power on your audio sources and audio playback system. Plug the included 5 volt

DC power supply into the Digital Audio Extender sender unit. Observe that the red

LED on the receiver unit lights up. If it does not, examine all connections carefully

and try again. Upon successful powered connection of the sender and receiver, you

should hear pristine digital audio on your digital audio playback equipment con-

nected to the receiver unit.

Please refer to the next page (page 4) for a detailed panel layout showing

all connectors on the sender and receiver units.