Hardware manual

6
How to Connect the Digital Signage Creator
1. Connect an HDTV display to the output port on the rear panel of the Digital
Signage Creator using the included 6 foot HDMI cable.
NOTE: A VGA monitor can also be connected to the Digital Signage Creator.
The HDMI and VGA ports are active at all times.
2. Connect an amplifi ed speaker or audio device to the 3.5mm L/R analog
stereo output for external audio support.
3. Optionally connect a 3.5mm to DB-9 serial cable to the 3.5mm mini-plug
serial port. This port is used to control the Digital Signage Creator using
RS-232.
4. Connects the Digital Signage Creator to the network using Ethernet cabling.
NOTE: If the Digital Signage Creator is connected directly to the PC, a
crossover cable must be used.
5. Connect the 5V locking power supply to the Digital Signage Creator. Do not
overtighten the locking connector. Plug the power supply into an available
wall outlet. The Status Indicator on the front of the unit will begin fl ashing
bright green indicating that the Digital Signage Creator is powered.
CONNECTING AND OPERATING
THE DIGITAL SIGNAGE CREATOR
Using HDMI
Using VGA
Gefen Digital
Signage Creator
®
EXT-DSC
VGA CABLE
ETHERNET CABLE
HDMI CABLE
USB Flash Drive*
*USB Device, used for additional storage, is optional
Router