DVI Super Booster Plus USER MANUAL www.gefen.com DVI Super Booster Plus USER MANUAL www.gefen.
ASKING FOR ASSISTANCE Technical Support: Telephone (818) 772-9100 (800) 545-6900 Fax (818) 772-9120 Technical Support Hours: 8:00 AM to 5:00 PM Monday thru Friday. Write To: Gefen Inc. C/O Customer Service 20600 Nordhoff St. Chatsworth, CA 91311 support@gefen.com www.gefen.com Notice Gefen Inc. reserves the right to make changes in the hardware, packaging and any accompanying documentation without prior written notice. The DVI Super Booster Plus is a trademark of Gefen Inc. © 2008 Gefen Inc.
TABLE OF CONTENTS 1 Introduction 2 Features 3 Panel Layout 4 Connecting and Operating the DVI Super Booster Plus 5 Auto Equalization 6 Specifications 7 Warranty TABLE OF CONTENTS 1 Introduction 2 Features 3 Panel Layout 4 Connecting and Operating the DVI Super Booster Plus 5 Auto Equalization 6 Specifications 7 Warranty
INTRODUCTION Congratulations on your purchase of the DVI Super Booster Plus. Your complete satisfaction is very important to us. The DVI Super Booster Plus extends the length of any DVI cable by regenerating the DVI signal before it is output to the DVI monitor or projector. The DVI Super Booster Plus will clean out the digital noise (sparkles) in your picture. The DVI Super Booster Plus is connected with a DVI (male to male) cable from the computer DVI graphic port to the DVI Super Booster input.
FEATURES Features • Perfects digital video sent over long stretches of DVI cables • Extends DVI displays away from the HDTV source • Maintains highest Single Link resolutions up to 1080p/1920x1200 • Supports DDWG standard for DVI compliant monitors • HDCP Compliant Includes: (1) DVI Super Booster (1) 5VDC Power Supply (1) User’s Manual 2 FEATURES Features • Perfects digital video sent over long stretches of DVI cables • Extends DVI displays away from the HDTV source • Maintains highest Single Link resol
PANEL LAYOUT Front Panel Manual EQ Adjustment Power LED Indicator DVI In Back Panel DVI Out 3 PANEL LAYOUT Front Panel Manual EQ Adjustment Power LED Indicator DVI In Back Panel DVI Out 3
CONNECTING AND OPERATING THE DVI SUPER BOOSTER PLUS 1. Connect the long DVI cable from the source into the “DVI In” on the front of the DVI Super Booster Plus. The DVI Super Booster Plus is placed next to your display to regenerate the DVI signal. 2. Connect a short DVI cable from the “DVI Out” connection in the back of the DVI Super Booster Plus to your display or projector 3. Plug the 5V DC power supply into the DVI Super Booster Plus. 4. Plug the 5VDC wall mount power supply into the wall outlet.
AUTO EQUALIZATION ON 1 Remove the silver tape to expose the Dip Switch Bank 2 Manual EQ Long Cable ON 1 Auto EQ ON 2 Manual EQ Short Cable Dip Switch 2 can be used to turn on the automatic equalization function. Use this setting for ease of setup as this mode will automatically tune out unwanted video noise. To do this, turn Dip Switch 2 to the ON position. No manual adjustments to the EQ can be made in this mode using the EQ Trim Pot on the front of the unit.
SPECIFICATIONS Video Amplifier Bandwidth ............................................................................ 165 MHz Input Video Signal ................................................................................... 1.2 volts p-p Input DDC Signal .............................................................................. 5 volts p-p (TTL) Maximum Single Link Range ....................................................... 1920 x 1200 x 60hz DVI Input/Output Connector Type ......................
