User manual

1 DVI/HDMI Mode Selector Switch

This switch will set the video mode. DVI mode is intended for use with

computers and will support resolutions of up to 1920 x 1200. HDMI mode is for

use with consumer HDMI devices and supports HDCP and resolutions of up to

1080p Full HD. There are also distance limitations associated with the different

modes. Please see page 10 for details.

2 Audio Input Selector Button

This button is used to select the audio input source. There are three input

options: Audio (analog stereo), Coax (digital S/PDIF), Optical (digital TOSLINK).

Each press will cycle through these selections.

3 Audio Selection LED Indicator

This LED will be active when the Audio (analog stereo) audio source has been

selected.

4 Coax Selection LED Indicator

This LED will be active when the Coax (digital S/PDIF) audio source has been

selected.

5 Optical Selection LED Indicator

This LED will be active when the Optical (digital TOSLINK) audio source has

been selected.

6 Reset Button

This button is used to cycle the power off and on. In most cases this will force

the source to re-establish a link with the endpoint device. This will also force the

source to re-read the EDID.

7 Optic B LED Indicator

This LED will indicate the status of the connection between the sender and

receiver’s 2 pair of LC f ber optic cables labeled Optic B. This LED will be active

when a valid link between the sender and receiver has been established.

8 Status LED Indicator

This LED will indicate the status of the unit and will be active when all devices

are properly connected and indicates that the unit is working within specif cation.

9 Optic A LED Indicator

This LED will indicate the status of the connection between the sender and

receiver’s 2 pair of LC f ber optic cables labeled Optic A. This LED will be active

when a valid link between the sender and receiver has been established.

10 Power LED Indicator

This LED will become active once the included 12V DC power supply has been

properly connected between this unit and an available wall power socket.

SENDER UNIT PANEL DESCRIPTIONS