User`s manual

EDID NOTES, CONT’D

EDID Modes

The diagram below illustrates the DIP switch bank (of 4). The 8 DIP switch bank

functions are outlined later on this page.

DIP SWITCH Function

1 IR Channel

2 IR Channel

3 EDID Mode

4 N/A

Use DIP switch 3 to set the desired EDID mode.

LOCAL EDID Mode (Switch 3=OFF) DEFAULT

• EDID that is stored in the LOCAL memory location is passed to all inputs.

• By default, during each power-on process the connected display’s

EDID will be automatically copied to each of the inputs’ LOCAL EDID

locations.*

• The EDID stored in the LOCAL locations can be overwritten with another

EDID from the following locations (These options can only be initiated by

using RS-232 serial communication commands) :

• Built-in EDID memory bank (up to 7 EDID records can be stored)

• EDID collected directly from the input display*

• Externally uploaded via the RS-232 command set

*For the default EDID writing process to be successful the connected display

must be powered on.

DS (Down Stream) EDID Mode (Switch 3=ON)

• EDID is passed directly from the connected display to the currently active

input.