User manual

EDID MODES

EDID Modes

The diagram below illustrates the 4-position DIP switch bank (containing 4 small

white toggle switches as shown). The functions of the switches are as follows:

DIP SWITCH Function

1 IR Channel

2 IR Channel

3 EDID Mode

4 N/A

Use DIP switch 3 to set the desired EDID mode. (UP is On)

How to set the two EDID Modes:

1. LOCAL EDID Mode ON (Switch 3 = OFF, FACTORY DEFAULT SETTING)

• During power-on, the connected display’s EDID is copied to all four

LOCAL EDID storage locations at once. EDID stored in LOCAL memory

is then passed to all input sources.

• The EDID stored in the LOCAL locations can be overwritten with another

EDID from the following locations:

• Built-in EDID memory bank (up to 7 EDID records can be stored)

• EDID collected directly from the input display upon power-up*

Note: All changes to EDID in Local EDID Mode will be lost upon power loss.

2. Local EDID Mode OFF (Switch 3 = ON)

• The DDC signal of the connected display is routed directly to each input

source. Each time a new source device is selected, EDID is transmitted

from the attached display to the currently selected input source. (This

mode will successfully pass HDCP signals.)

*For EDID writing to be successful the Switcher must be powered on.