User manual
page | 8
Local Area Network (LAN) Connection
In order to connect the DVI KVM over IP with Local DVI Output to a Local Area Network
(LAN), both the Sender and Receiver unit must rst be set to DHCP mode or static IP
mode. DHCP mode will use the DHCP server to automatically assign an IP address for
each Sender and Receiver unit that is connected to the network. Static IP mode will allow
the IP address for each Sender and Receiver unit to be congured manually. Contact your
network administrator if necessary.
1. Follow the connection steps under Using a Direct Connection.
2. Connect an Ethernet cable from one of the LAN ports on the Receiver unit to the
network.
3. Access the Web interface for the Sender unit by entering its IP address in the address
bar of the Web browser. If the IP address or Video Channel is not known, see
Displaying the IP Address and Video Channel
4. Set the DVI KVM over IP with Local DVI Output to the desired network mode (DHCP
or static). Refer to Setting the IP Mode for instructions.
5. Repeat steps 3 and 4 for the Receiver unit.
IMPORTANT: The use of a Gigabit switch with 8K “jumbo frame”
capability is required when connecting the DVI KVM over IP with
Local DVI Output to a network.
Sender unit
Receiver unit
Connect to LAN / DHCP server
Getting Started
Installation