User manual

page | 14
Displaying the IP Address and Video Channel
If the IP address or the video channel of a Sender and/or Receiver unit is not known, then
use the following procedure for any Sender or Receiver unit on the network.
1. Press and release the -/Select button on the front panel of the Receiver unit.
The current video channel will be displayed in the top-left corner of the screen.
In the example, above, the current video channel is set to 0.
2. Press the -/Select button again to change the video channel from 0 to 255.
Pressing the -/Select button will decrement the current channel number. Pressing
the +/USB button will increment the current channel number. See Setting the Video
Channel for more information.
Channel:0
Press the -/Select button
Basic Operation
Operating the DVI KVM over IP with Local DVI Output